Diamond Core Drill Bit - with stand in box - 2200 W - 1300 rpm

On a construction site, time is money, and the demands on the machines used are correspondingly high. With the core drill from MSW, you can reliably drill holes in hard building materials such as concrete, masonry or asphalt. Use the core drill stand supplied when drilling, then even large holes with a diameter of up to 202 mm are possible. This set already includes three diamond core drills with diameters of 52, 82 and 102 mm. With these drills, for hard walls you use the micro-impact mode, which creates a very fast, yet soft hammering effect. All devices and accessories are conveniently transported in a sturdy box.

With the diamond core drill you have access to a power of 2200 W and a maximum speed of 1300 rpm for hand-guided core drilling up to a diameter of 162 mm. For best drilling results, use two power levels, taking the largest diameter drill at the lowest speed. With a core drill rig, you not only increase the precision of the drilling, but also use larger drills up to 202 mm. Whether freehand or with a stand, the core drill is intended for professional users who already have experience with similar equipment due to its performance.

When drilling with the core drill stand, you use a guide rail with a length of 510 mm. Attach the drill to the holder with a diameter of 60 mm. You can select the drilling angle between 0° and 45° in steps of 5. You move the diamond core drill along the guide rail with a T-handle, each of which you adjust in length for better handling. When drilling, rely on reliable water cooling. A connection is directly integrated in the unit. This reduces wear on the drill, you maintain the machine less and achieve a longer service life. 

Use concrete core drills with different diameters, which you connect securely to the tool via the holder. Use the granite core drill to drill into reinforced concrete, cement, masonry, asphalt and natural stone. The 2.8 m long power cable offers you maximum freedom of movement. Thanks to the residual current protection circuit (PRCD - Portable Residual Current Device) integrated in the cable, you always use the unit safely. If there is a short circuit in the area of the core drill or the cable, the unit will immediately stop operating.